NXDNReflector connector

You can use this connector to connect to a network which supports the NXDNReflector protocol, like NXDNReflector servers.

Note

The easiest way is to use the Quick Setup menu on the device or the Quick Setup page on the web interface to set up this connector.

Talkgroup handling

NXDNReflector servers handle only one talkgroup. You can find each server’s talkgroup ID in the server list, or if you enable Advanced mode, then the talkgroup ID setting will be shown.

If you did not use the Quick Setup to set up the NXDNReflector connection, then make sure you send your calls as a group call to the talkgroup ID, otherwise the server will ignore them.