DMRplus dongle connector
You can use this connector to connect to a network which supports the DMRplus dongle protocol like DMRplus, Phoenix, DMR-MARC, XLX.
The easiest way is to use the Quick setup to connect to these networks.
You can change the used reflector ID by starting a short private call on your radio to the desired reflector ID (between 4000 and 5000).
Cross mode usage
The DMRplus dongle connector is a DMR connector, but it supports D-STAR®, C4FM and NXDN® cross modes.
D-STAR® notes (openSPOT4 Pro only)
You can switch reflectors with a D-STAR® radio using two methods:
- Set the reflector ID as the D-STAR® radio's URCALL, then start a short
call. After the short call, set back the URCALL to
- DTMF codes: enter * followed by the reflector ID in DTMF code.
If you use a C4FM radio, make sure it is in digital narrow (DN) mode, otherwise your calls can't be converted and only silence will be sent to the network.
You can switch reflectors from your radio by entering Cross mode group call DTMF code (by default it's *) followed by the reflector ID in DTMF code, or use the Wires-X® button menu to select/search for servers.
Example: to switch to reflector 4770, enter DTMF code